Yes—stainless steel can be welded successfully, and most fabrication shops already have the equipment to do it. The material is not fragile or “unweldable”; it simply punishes poor preparation more ...

Answer first: the tools and equipment for metal fabrication that decide whether a job is profitable are the machines that cut the plate, turn the workpiece and keep the torch in position - not the t...

MIG welding is most effective when four conditions line up at the same time: the base metal is clean and dry, the wall thickness sits roughly between 3 mm and 12 mm, the arc is shielded from moving ...

An I-beam is a structural steel section with an I-shaped cross-section: two parallel flanges connected by a single vertical web. That is the definition in one line. Everything else in a working desc...

Short answer: a plasma arc is an electrical discharge that travels through a column of ionized gas instead of through solid metal. Constricted by a small nozzle orifice, that column becomes a jet of...

Read the beam designation from left to right. The letter tells you the cross-section family, the first number is the nominal depth in inches, and the number after the multiplication sign is the weig...

When a buyer evaluates welding equipment, the first question is rarely about duty cycle or amperage. It is about which process fits the workpiece. Here is the conclusion up front: MIG is the faster,...

H beams and I beams are not interchangeable. The simplest way to understand the difference: an H beam has wide, parallel flanges and a thick web, which makes it stronger and heavier; an I beam has n...

Welding stainless steel to carbon steel is a common but technically demanding joining task. The reliable route is straightforward: select an over-alloyed austenitic filler such as ER309L, use a low-...